The screw speed control mode is an important factor in the production of waste plastic recycling granulators

In the production process of old plastic recycling granulators, the screw plays a very important role. It can be said that the screw speed ratio control is one of the factors that affect the production process of plastic granulation. Therefore, the requirements for these tasks are very strict.

Adjusting the screw speed and stability is an important process requirement for the main drive of a waste plastic recycling granulator. The screw speed ratio directly determines the glue quantity and extrusion speed. Normal production always starts at the highest speed possible within the available speed range to achieve high output. The desired screw speed for the operation of a waste plastic recycling granulator should be high. High-speed stability is required because speed variations will lead to changes in the quality of extrusion and cold extrusion. Therefore, it should not change due to fluctuations in the traction line speed, which will lead to changes in the cable diameter. Changes in the same cable may also cause large fluctuations in the line speed of the traction device. The screw speed and traction control console can be reflected in the corresponding detection instruments. Extrusion should be closely observed to ensure quality and increase production rate.

The screw of the modern waste plastic recycling granulator is made of high-strength alloy steel, a corrosion-resistant material, to ensure its application and productivity within the granulation range. Jinli invites you to join us.